A labyrinth is used to prevent the gas from leaking through the space between a rotating and a static device and thus reducing the efficiency. The leaking air is trapped in the successive stages of a labyrinth. It can be straight (Figure 46) or stepped (Figure 47). A stepped labyrinth is used if the gas is compressed or expanded, leading to a decreasing and increasing diameter of the rotating deviced, respectively. In a stepped labyrinth the static device is usually covered by a honeycomb structure.
The geometry of a labyrinth can be fixed or flexible during a calculation. For a fixed geometry the gap distance s is constant. For a flexible geometry this gap is defined as the distance between two nodes. These nodes have to be genuine structural nodes and should not belong to the fluid network. In a thermomechanical calculation this distance can vary during the computation. Whether the geometry is fixed of flexible is defined by type.
The formula governing the flow through a labyrinth has been derived in [14] and for the discharge coefficients use was made of [33], [29], [11] and [60]. A fixed labyrinth is described by the following parameters (to be specified in that order on the line beneath the *FLUID SECTION, TYPE=LABYRINTH card):
A flexible labyrinth is described by the following parameters (to be specified in that order on the line beneath the *FLUID SECTION, TYPE=LABYRINTH FLEXIBLE card):
Please look at the figures for the meaning of these parameters. Depending on the kind of labyrinth, not all parameters may be necessary.